Is it possible to change how the Hulk set is labeled? Maybe this isn't even the source of the problem, the programmer would know better than I. When you search "Hulk" (as in looking for characters named Hulk), your search result brings up every figure from the Hulk set. This wasn't a problem with Superman or Captain America because figures in the Superman set were labeled SM### and Captain America set figures were CA###. Figures in the Hulk set are labeled HULK###. Would it fix this issue to label them HLK### instead?

Thanks for reading!

I don't think it's nice to label people.

All joking aside that does sound better. Sounds like a simple enough solution to the issue as well.

I just thought it would be good to fix this before the sets are released. We all know people (and newer members) are going to be searching the Hulk set in the Units Section quite a bit in coming weeks. Might as well try to make it as smooth as possible.

It makes sense. No doubt about that.

It would making searching much easier, especially for newer forum goers.

Ah! Interesting.

Until you mentioned this I didn't realize he'd had the space to use "Hulk" in the indexing. It's a good point, though I can live with it if they decide it's too much of a bother to go back in and change it to "IH", "HLK" or some such.

Yeah; I just threw it in there ... but you're right; it should probably be "IH"; but I probably just need to remove it from the index because I doubt people are searching for "sm002" ... because they can just browse to it if they already know that much information.

Thanks Typhon, much appreciated!

Um...a little more than a month later, and this is still a problem.

I search "Hulk" in the units and the entire set comes up.

yeah; I know. I still haven't gotten around to fixing it. I know it's supposed to be 'IH###" instead of HULK###, just haven't gotten around to it. Hopefully this week.

Ok; this is done. Sorry for the delay; but I have to make sure that all the inventory and everything was also relabeled. The entire system runs on the unit id ... so it's not an easy switch.